Pottstown Pa Welding Job – Steel Stair Treads

This welding project was done last year at the New York Plaza in Pottstown PA. The welding job involved fabricating the treads for the steps which were rusted out, which I did in my shop, then transported them to the job site and installed.

 

Pottstown PA Welding Fabrication - Steel Steps

Total Time for the Pottstown Welding Job

First I had to remove the old steps, which involved a sledge hammer and a grinder. The old steel steps were so rusted, that many of them came out very easily with the just the sledge hammer. I also had to rope off the area, and make sure no one would come through the door and get injured.

After taking measurements, I went back to the shop and began the fabrication.

For the treads I used 3/16″ steel.  Once fabricated, I took the steel treads back to Pottstown and installed.

Total time for the job with fabrication, removal and installation: 2 days.